Copper(II) Acetate,CAS : 142-71-2

E FORU specializes in producing high purity Copper(II) Acetate,CAS : 142-71-2 with the smallest possible average grain sizes,Purities may include 99%, 99.9%, 99.99%, 99.999% and 99.9999%, which are sometimes referred to as 2N, 3N, 4N, 5N and 6N. 99.99995% (6N5), and in some cases up to 99.99999% (7N) and 99.999999% (8N),E FORU produces to many standard grades when applicable, including Mil Spec (military grade); ACS, Reagent and Technical Grade; Food, Agricultural and Pharmaceutical Grade; Optical Grade, USP and EP/BP (European Pharmacopoeia/British Pharmacopoeia) and follows applicable ASTM testing standards. Typical and custom packaging is available. Our standard powder particle sizes average in the range of - 325 mesh, - 200 mesh,- 100 mesh, 10-50 microns and submicron ( 1 micron). We can also provide in the nanoscale range.Powders are also useful in any application where high surface areas are desired such as water treatment and in fuel cell and solar applications. Nanoparticles also produce very high surface areas.Production of metallic Acetate materials including, cobalt Acetate, chromium Acetate, hafnium Acetate, molybdenum Acetate, niobium Acetate, tantalum Acetate, titanium Acetate, vanadium Acetate, zirconium Acetate, and numerous others.An acetate is a salt formed by the combination of acetic acid with a base (e.g. alkaline, earthy, metallic, nonmetallic, or radical base). "Acetate" also describes the conjugate base or ion (specifically, the negatively charged ion called an anion) typically found in aqueous solution and written with the chemical formula C2H3O−2. The neutral molecules formed by the combination of the acetate ion and a positive ion (called a cation) are also commonly called "acetates" (hence, acetate of lead, acetate of aluminium, etc.). The simplest of these is hydrogen acetate (called acetic acid) with corresponding salts, esters, and the polyatomic anion CH3CO−2, or CH50COO−..Quality inspection department staff which uses atomic spectroscopy, x-ray diffraction analysis, scanning electron microscopy, glow discharge mass spectroscopy (GDMS), and BET surface area analysis, among other technologies, to ensure that the elemental composition and structural properties of each product rigorously adhere to our standards.Additional technical, research and safety (MSDS) information is available,